Or the bag cover will not latch securely.Īlso, the motor and exhaust filters should be cleaned at each bag replacement. Make sure the bag is tucked into cleaner. Make sure the bag is installed into the holder sliding bag collar into slots to secure. The dust bag holder is an important part of this vacuum. The dust bag must be changed and the filters cleaned or replaced if the window of the Clean Filter Indicator changes into red when the cleaner is operating at maximum power and the nozzle is raised from the floor. REPLACING THE FILTERS Filters should be cleaned or replaced when they become visibly soiled or suction power is reduced.Īlways operate the cleaner with the filters installed to avoid motor damage. Eureka Rally 2 Canister VacuumĪlso, the motor and exhaust filters should be cleaned at each bag replacement. Or the bag cover will not latch securely. This is likely to happen at the canister end when the bag gets too full. If it fails to fall through, there's a clog that needs removed. Disconnect at both ends and drop a coin in one end. You should also check the hose for clogs. This is one of the benefits of having a vacuum that shuts off when the bag is full. My eureka rally 2 cannister vac, just stopped working, it's 2 weeks old Seems like it blew a fuse, is that - Eureka Rally 2 Canister Vacuum with question. 6 Style T Bags 61555B Eureka Canister Vacuum Cleaner Rally 2 Maxima Twin Lite.
When a vacuum is used for long after the bag is full, the motor can overheat to the extent that the motor burns out.Įureka Rally Eureka 2 Person Tent. If it still doesn't work, take it to a repair shop to be checked. Give the vacuum time to coold down, then try again.
Any restrictions or blockage can cause the motor to over heat. Air must pass completely through a vacuum starting at the floor where it picks up the dirt through all the canisters, filters, bags, etc. But first make sure the overheating is not being caused by a blockage somewhere or the bag is too full. If it is defective the motor must be replaced to solve the problem. If your model does not have an external reset button it is most likely a sensor inside the motor. Some vacuums install an external heat sensor with a reset button that you must push to re-start the vacuum. Your Sensor most likely has an internal heat sensor that is shutting off the motor.
0 kommentar(er)
